at discs

[insainwayne]

Hello everyone, just a question, I'm keeping a eye on flebay for some standard front discs for saras bike, just wanted to know do discs from any other honda's fit?

Also wanting to plan a laning trip again soon, on my war bike, must be a Sunday, will start at Verwood and head out to plain, if anyone has any ideas or dates. Drop me a mail.

[meljordan]

Hi buddy the cheapest ive seen them new is £58 each at

http://www.bitzforbikes.co.uk/Honda/XRV_750/Y_00_-_03

still a lot of money though.fleabay.de might be worth a look. as to a run-out on the little bikes yes definitly will be at ace this sunday to support herr vador and thelongestday but then any sunday is good.

[Chad]

Hello everyone, just a question, I'm keeping a eye on flebay for some standard front discs for saras bike, just wanted to know do discs from any other honda's fit?

Also wanting to plan a laning trip again soon, on my war bike, must be a Sunday, will start at Verwood and head out to plain, if anyone has any ideas or dates. Drop me a mail.

thats a tricky question


those that mels posted are a fairly good post and you would be best going for new ones if you can mate

just remember to run them in nice and easy over a period of say 30-40 miles progressively increasing the braking (no hard braking) to prevent the new ones warping

[icenian]

David Silver usually has genuine Honda discs for about 60 pounds each (often cheaper than dodgy aftermarket ones).

http://www.davidsilverspares.co.uk/parts/

[Simon]

on this topic, can anyone tell me the thickness the rear disc has to be as mine is starting to look rather thin. Or where i can find out?

[Stormforce8]

There's a set on Ebay at the moment here - item # 190209462910

[YEN_POWELL]

on this topic, can anyone tell me the thickness the rear disc has to be as mine is starting to look rather thin. Or where i can find out?

I think the minimum thickness is stamped on the disc somewhere.

[Peltsi]

I think it was 3.5mm since mine was 3.0mm from the thinnest point of it. I bouhgt EBC discs. They were the cheapest I could find.

[fw750x]

Hi Simon according to the Haynes Manual it is 4mm, brand new it is 5mm .Francis

[YEN_POWELL]

I think the minimum thickness is stamped on the disc somewhere.

I've still got my 130,000 mile disc hanging on my garage wall as a souvenir. It has the words 'min thk 4mm' stamped into the centre of it.

I replaced it with an EBC disc which was fine and cheap too.

The front disc EBC replacements were rubbish though, not only do they rust like mad, but they don't work in the wet, even with the recommended pads. I will be replacing my current OE Honda discs (one has warped as usual) with Honda again now that the cost has come down to reasonable levels.