RD07a dies after a bath

[peterpan241]

After a faultless 150 mile run back from the Dragon Rally & as it was very road-dirty set about with a cold water pressure washer. After drying of bike it started & I rode it about 300 yards before it cut out. Ignition lights all working, cut out switch in the on position but when the starter is depressed nothing happens - no relay clicking, etc.
Is there a main fuse which would make this happen? Only asking to save some possibly time wasting.
Ideas appreciated

[gsdman]

Main fuse on my RD04 is on the starter selanoid, could be that or bad connections on starter side of things.
Tez

[kitped]

Maybe worth checking the sidestand switch also?

[Nickel Arse]

I'd start with the simples first if the fuses are OK
Sidestand switch
kill switch

[Paul-S]

I'd start with the simples first if the fuses are OK
Sidestand switch
kill switch

+1 on that

[Lord Vader]

Should not have washed the bike,just ask whealie or Yen

[peterpan241]

Thanks for your inputs guys , now all sorted. The lack of power to the starter button was fuse 3 (10amp) had blown. It had blown (6 fuses later) due there being water in the multi pin plug of the starter solenoid and 2 of the 4 plugs on the ignition ecu (? to the rear of the starter solenoid). All connections filled with waterproof grease so shouldn't arise again.

All set for the Welsh Invasion ( I know I'm already nearly there )