Honda XRV Forum banner

brazing

  1. Anyone used Durafix Aluminium brazing rods

    Bodgers Corner
    Not so much a bodge, more something a bodger might find useful. Came across these while researching fabrication methods for some potential bodges I have in mind and thought I'd post it up for comment. - Durafix England So, has anyone used these or similar before? If so, what did you think of...
  2. Brazing techniques

    Mechanical Advice
    Does anyone have any brazing experience & tips to share. I'm looking at light duty stuff in steel but can aluminium be succesfully brazed too? I have a plumbers type blowtorch, what else is required regarding flux & rods & using the above blowtorch, what thickness of steel could be succesfully...
  3. Welding or brazing stainless steel

    Mechanical Advice
    I have a fine crack around a third of the circumference of the centre section of my BSM exhaust, close to the joint with the down pipe. It doesn't blow much, but I'll be needing to put my AT through an MOT very soon, and in any case it would be far better to deal with it before the crack...
Top