bushes

Hi Guys, Later in the year I will be rebuilding my front forks with progressive springs, in respect of the seals do I need to order one of these kits: Kit Contains: 2 Oil Seals 2 Dust Seals 2 Retaining Clips 2 Inner Bushes 2 Outer Bushes Or can I just order the seals? Also what fork oil...

Does anyone knows if the rubber bushes from the top yoke that takes the vibration from engine/road can be taken from something else? If there are any bushes compatible? as the same sizes? it's within the nr 14

Can anyone tell me how to remove the bushes either side of the swing arm? I want to strip everything out before paint and I want to renew the bearings anyway. There was a little bit of play I could feel. Here is a pic: Thanks, Adam.

Hi all Can any body help! I've just managed to get hold of a xr250r engine and its missing the 2 tophat bushes that go into the crankcase to support the swing arm bolt. Anybody help me with these please. Thanks Simon

This year i replace the fork stanchions, bushes and seals on my year 2000 sd01, when it came to mot i got an advisory for play in the slider. Does anyone know if the sd02 forks fitstraight on or do I have to fit any other sd02 parts? (caliper brackets etc)

On striping down my 1987 600's rear suspension I noticed only one of the three metal inserts in the rubber bushes will rotate (the one with the grease nipple) is this correct or should all three rotate ?

Morning, The AT has just failed it's MoT due to a rather startling amount of up-down play where the top of the monoshock mounts to the frame. Looking at the parts fiche I can't make out whether there's a replaceable bush in that part of the shock or whether the whole unit is going to need...

Has anybody got any spare rubber bushes and the bolts for the sump guard for an RD04. I thought I would try on here instead of spending 2 hrs on the mircofiche getting all the part numbers. Also if you have the bolts that piece the 3 halfs together I think the are 6mm that would be great. Thx...

Anyone know best way to straighten bent motad crash bars. someone at some point must had fairly hard fall as the left one is bent in and rubbing hard againt the fairing Also any of the spacers/bushes that so intetween the skidplate and frame around? i need get myself a small lathe

Hi all (yep, I have an LMF at last:D) Where could I buy a set of fork bushes and if poss some damper piston rings? I obviously have a lot to learn about honda part numbers:confused:, but just the part numbers would be a start!! Cheers Cubby PS is it just me, or does the outside air...

I'm just stripping down a spare tank ready to be sprayed to match my new Boano fairing. Does anyone know how to get the two rubber bushes at the rear/base of the tank out, without destroying them? Thanks!

Its the only part of the TA that isnt feeling right. There are handlebar bushes under the top yoke where the risers bolt in I suppose to eliminate vibes. I was wondering if renewing these it would tighten it up and make the steering feel less vague. The only problem is I phoned David Silver and...

the bushes on my 93 600 ta are a bit sloppy ive asked at my local dealer but honda dont do the bushes only top yoke with bushes fitted does any one know of any pattern parts cheers