https://i1367.photobucket.com/albums/r784/adamnightingale/DT200R%20Restoration/Capture_zps1u7mvupa.jpg
Hi All
I am trying to get a severely corroded RD04 running, The carbs have completely seized and it appears to be due to external corrosion. Is there a good resource available to understand...
Having a bit of a clear out and the following are up for sale, RD03 rear pegs, rear brake disc guard, lights, rear caliper holders. Rocker covers from an RD07 but I think are the same for RD04. Exhaust guard is provisionally sold. Open to offers.....Also have quite a few front and rear sprockets...
I have two frames that I have inherited as part of a bundle of spares that came with an 80's XL185 I have purchased, I only have a V5 for the complete bike but the other frames have clear frame numbers and the seller states they were complete road registered bikes when he stripped them in the...
just wondering if any one out there has tried put put a twin pipe of a 2013 450 on a 2005 . if so what mods needed , my thinking is that i would need to make a mounting point on the rear subframe for the can and a new panel to clear the can. any help please , and does it give any more power ?
Having trouble with a weak spark on my Honda XL250R. We think the source coil is at fault but on test it gives 76 Ohms resistance. The correct resistance is unclear as the manual we have says reading should be in the range 200 to 500 Ohms. However later it says that for post 1981 the reading the...
Size LARGE
Selling as i dont use it and have another tour x, its in excellent condition with only a slight mark on the back where it was resting on the wall on the shelf. There is a stuck on GO Pro mount which can easily be removed.
The Senna intercom does NOT come with it and will be taken...
Hi All. The throttle on my bike recently became stiff to the point it would stick open. Before this it was working fine and there were no changes to the routing of the cables etc. I took it apart and it all looks ok. I put oil down the lines and they are totally free. I cleaned the carb end...
I took my 2008 700 Alp out today for a 30--40 miles run seeing as the sun was shining, at last. After a not too hard a thrashing whilst heading home I rode through the local town. Whilst amongst the slow traffic I thought it sounded a bit lumpy once or twice. A quick blip of the throttle seemed...
As title, I have a front wheel from an RD03 and lose forks all in good condition. Was going to keep them 'just n case' but need to have a clear out...
Message me if any interest.
£100 for front wheel and disc and £80 for forks.
Collection from Huntingdon, Cambridgeshire
Cheap TA 600 parts for £80
https://www.ebay.co.uk/itm/HONDA-TRANSALP-600-SPARE-PARTS-ASSORTED-PARTS-TO-CLEAR-JOB-LOT/302615414581?hash=item467548c735:g:MucAAOSwGllaafck
Arai rx7 GP for sale...SIZE XS 53-54 CM.
Worn once ( other than that not used) spare helmet.
Metallic silver.
Comes with standard clear visor, spare race visor and helmet bag.
Approximately £500...New...will accept £350... Or nearest sensible offer.
Location....DURHAM.
Can't upload photos...
Well we have gone from this
to this
then...
and
to
and..
Frame, yoke, swingarm and wheels all powdercoated. Engine sprayed matt black. Tank stripped and clear lacquered.
I know it wont be to everyone's taste on here, but I am pretty happy with it so far.
There are a few...
I'm having a bit of a clear out of stock and the following are for sale:
FX650 / SLR650 / FMX650 Camshaft, genuine Honda, brand new in box £100
FX650 CDI, tested and proved working, 3 for sale £50 ea.
I'm open to offers but I don't want to do any swaps or trades.
Hi guys
1979 500 xl sz for sale
Nut and bolt restoration
Imported from Holland to the U.K.
Nova clear but not registered in U.K.
Picks below
Also on uk eBay
For more details please message me
Offers around £2300
Thanks
Hi,
I'm looking to replace the amber lens on my 1992 Transalp for clear or smoke glass. I found these but it says it fits only models up to 1990. Is there really a difference pre/post 1990? I thought they were the same until 1993.
FOR Sale FCR Pumper carb 40mm
I bought this carb for my new build
however after offering it up it became clear it will not fit due to the altered frame loop
This carb is rejetted with the correct needle jet(nctv 2nd ring down).
These jets and needle jets came to £40 on there own and have never...
Hi Guys,
I am looking to purchase some pannier frames for my RD07A and have been in touch with Alex at Heavy Duties.
My bike has a Touring Scotoiler fitted which mounts between the mudguard and the number plate, I am concerned the cross piece that connects the two racks at the back may...
Hi does anyone have a good clear outer screen or front cover for an RD07 tripmaster, looks like a previous owner has lacquered the case and it's all gone crazy!
Cheers
JTP
I'm having a bit of a clear out in the loft and found this, It's a Rothmans Honda Flag/Banner, great for all you Dakar fans.
It would look great hung up in a garage or something like that. It's pretty big, 255cms x120cms and is made of a silky type of material.
There are a few very small...