Has anyone here replaced their steering head bearings? If so...how did you remove the bearing 'race' that is on the lower yoke? This thing...
The internet suggests
- using a chisel
- using an angle grinder
- using a dremel
- using two screwdrivers
- using some sort of special tool
Just wondering if this is normal on a 650 Alp - there seems to be a serial / engine / VIN number party visible on the clocks - Not sure what or why it’s like that you’d think the entire number should be seen????
I need a new screen and after lots of searching around I have found the one shown in below.... I now need to know where I can buy this exact same screen from. Any suggestions please? Advance Thanks