A strange request I know, but does anyone have any old front brake discs for an RD04 lying around?
I’m upcycling an unserviceable front wheel into a clock for my garage and I think it’ll look better with a disc on it.
Happy to pay for postage.
Sent from my iPhone using Tapatalk
I desperately looking for a front brake master cylinder for my 2001 Dommie. I completely trashed the screws for brake fluid lid and need to replace the whole thing now. No luck on Ebay sadly.. any one have a spare one?!?!
Or someone have any suggestions on replacements that would be...
Front brake on my 1985 XL600 was getting spongy so after trying the obvious brake bleed I've order a kit online to do the master cylinder, but it's about 1mm too small in the old diameter measurements. I then ordered a second kit (from a different place) and was sent the same kit.
not been on here here for a while but just picked up another little project, a 1990 xr100 and im looking for a few bits for it, mainly rear panels and front brake hub but anything considered.
Brake light dosen't come on when I pull on the lever,I've taken the wires off and joined them up and the light comes on,so bulbs ok,wires ok,I have taken the switch off and tested it with a simple meter and I'm getting a good reading,put the wires into the switch and try it by hand and it will...
Does anyone on here know if a front brake caliper from a standard RD 02 dommie or a SLR650 will fit onto USD forks from a 2006 CRF250R? :thumbup:
I dont fancy digging through the snow right now to get to my bike to measure them :rolleyes::rolleyes::rolleyes:
My front brake has rattled since I bought the bike.
Today I figured time to clean out the calipers and found I was missing the small spring from each side
Amazing the image has uploaded. the part numbered 8 spring pad are both missing; is this likely to be the cause of the rattle?