I would like to customise my FX650 and wonder if anyone has fitted alloy 3 spoke wheels [like those on a Suzuki GS500] to their Honda. If this is a doable how complex is it or is there an easy way of fitting wheels from another bike which need little modification. Any photos would be helpful.
Hi Folks, Would anyone happen to have a spare front wheel spindle they would like to off load? My Dommi one has a slight bend to it. I believe the FX and SLR (and some other honda models) has the same spindle. Thanks Jim
I want to save some coin, and instead of acquiring specific FX650 centre stand for my needs I am considering buying FMX650 centre stand for 1/3 cheaper instead. Anyone having any experience or comment on this ?
Is there any reason a CDI from and SLR wouldn't run in an FX650?
You'd need to chop the FX CDI plug from the loom and wire in the SLR CDI plug. Then the ignition rotor would need to be changed (the FX on has more pips on it).
I'm sure the TPS is the same on both bikes.
The only casualty I think...
The wiring loom on my 1999 FX650 is in a bad way near the CDI connector.
I have repaired it but ideally looking for replacement CDI connector or a very good loom.
What have you or suggestions on where to get a new CDI connector.
There are looms available from the usual places (i.e. ebay) but...
I've broken 2 bikes for my project and basically used the engine, swingarm, electrics and wheels from each one, so have quite a few parts spare if anyone is interested? One came with a new hagon rear shock too!
Hi. I bought a 2002 Honda fx650 vigor. The piston was knackered. So I got a new barrel and piston (2nd hand) and removed all the old piston from the engine. It has 75-80psi on compression. And the valves have been set to 10mm? What ever it is in the Haynes manual. It semi fires. Goes to around...