I’m on changing the output shaft on my 700 XL and having started it up after the rebuild I am getting a very light noise from the clutch side, my question is there anything that is peculiar to the clutch to make it noisy. When I pull in the clutch lever the noise disappears.
, there is also a...
I don't see how this makes sense ... but let me ask!
After installing kitpeds raiser kit (+6cm front and back) & removing db killer, my clutch slips.
Before I had no issue whatsoever (RD04 from 1992 with 87000km). I checked for free play on the clutch lever and there is more than...
I am doing a lot of off-road with my Africa (RD07) and in standing position i can't reach the rear brake pedal. So i am looking for a foot brake lever extension. Any suggestions? Do you think this do?
I'd like to experiment with a modification to the rear brake lever of my XL700 Transalp but want to keep my original lever in case it goes horribly wrong!
Are the splines the same across the different Transalp models (or any other Hondas)? This would open up the choice of spare parts/price...
Can anyone recommend hand guards for the above bike. Snapped my hand brake lever ( but managed to manufacture a mock-up for now) Looking at the twist grip there doesn't seem to be provisions for fixing a two point gaurd, which I would prefer (more solid) It seems to be a closed off tube...
Was hoping someone could help with a braking issue (front) on my 1991 AT RD04. I've rebuilt the calipers and fitted the master cylinder repair kit, bled the brakes and fitted new pads but there's absolutely no build up of pressure at the brake lever. A couple of times I've managed a very slight...
I need the help off you experts.
My rd03 runs really well.
But as it gets warm after maybe few miles the neutral light starts to flicker then goes completely. Bike still running fine. But if you turn it off starting is tricky. You need to pull clutch lever in, and have stand up to restart...
i have lost fuel tap lever. new one is 15 plus delivery. does any one have other alternative?
I have read that someone made a tube connection to handelbar so can be easier switched when needed..
Hi all started my xrv for the first time since i bought it after fitting some led indicators (long story ).Any how on strting the idle had been set too high so once the bike warmed up i reduced the idle spped to a respectable 1200,as i was lowering the clutch noise became louder like the...
My choke won't stay open on my bike. I can
Pull it open revs pick up all perfect but it seems
Like there is a bit of force pulling the lever back closed?
Can't seem to work it out. Has anyone come across
Is there anything to adjust?
Your wisdom would be much appreciated. Cheers...
Last weekend the gearlever on the XL600V got well bent up with the end getting under the footrest...and it could have been a lot of a problem..except i was rescued by a few nice blokes with a big vice and a hammer...ANYWAY...TopBuzz99 had previously put a post on here about a good...
Hi everyone,<br><br>Renewing camchains on 80k mile RD07, but I can't get sufficient slack to bolt cogs back on camshafts with chains in place. I need an extra 10mm upward movement for things to match up.<br><br>What am I doing wrong? Is there some way of adjusting tensioners to build more slack...
This is my XR400 which hopefully will take me to the Sahara later this year, but not before I check the valves and cam chain. Does anyone have the valve clearances and any special info I may need. It has the standard decompression lever.
Thanks in advance
Assume gear lever was worn, purchased new one, shaft also worn :( would it be ok to weld for now? I assume it's engine out and strip etc ?
Any other ideas ?
Could I drill through pedal and shaft tap it then add grub screw ?
What options do I have
Sent from my iPhone using Tapatalk