I have a red 1999 XL600V Transalp with a damaged headlamp cowl.
I have found a replacement cowl online which is red but I'm not sure the colour will match.
Does anyone know if there were different shades of red used on this model/year?
I've attached a picture of my bike.
It's quite an...
I was told it was intermittent when I bought the bike, and had been checked out and nothing seen to be wrong. So, investigations were made, and I soon discovered it barely reached the contact point inside the gearbox.
I’ll probably order a new one, maybe, and I didn’t want to leave the copper...
I am in the middle of deciding whether to replace an output shaft on the AT, XRV750 - 2002.
Can anyone give me a list of the parts I need to order, gaskets etc to do this job? - gonna use the VT750 shaft.
Also is there anything else worth doing whilst I have the engine in pieces?
I'm hoping to build a special dominator motor with a high compression piston - say 10.5:1
No problem I thought, as Wiseco do them for the XR650L - which is the same as the Dominator right?
Does anyone know 100% for sure if this is true of all XR650L motors because the Wiseco catalogue does not...
It's been a little while since I had the rear wheel of my RD03 off, and now I want to order some combined tyre levers and axle wrenches. Can anyone here tell me the dimensions I need? I seem to recall that it is 17mm and 24mm?
I am currently in Scotland, and my bike is back home in Norway...
Rear brake caliper including brake hose and master cylinder. Basically the complete rear brake assembly except the brake pedal.
Condition unknown but everything looks to be in good order. Photos available on request.
Asking 50€ for the kit.
Located in Sweden.
Shipping, including tracking and...
Well its winter again here in northern Germany. Bloody freezing and damp. I have a choice of parking my pristine AT in a damp garage, which I air as much as possible, or under a car port where it will stay dry with no problem with air flow.
The bike gets a coating of moisture in the...
My 2001 AT has 18,000 miles on it. It runs poorly and stumbles and vibrates a lot. Over the winter I think a carb strip and rebuild is in order.
Any thought as to have far should I go?
Fit new jets, gaskets, etc?
Replace diaphragms (if fitted)...
Has anyone used a lithium battery on they project.
Im looking to order the Aliant YLP09X which is equivalent to the YTX9-BS battery just a fraction of the size of it.
Just wanted someone to confirm that its the right one before i place the order.
Here is the link for the datasheets of the...
I think one off my cdi's have gone.
The bikes rev counter has gone crazy the bikes misfiring badly. Feels like it's running on one.
My question is
I don't think these are the original cdi's and I'm not sure what to order.
These read right on eBay but don't match mine
Or do I...
Hi can anyone help me with parts for my 1996 Africa twin I'm after con rods and big end shells and main shells when I try to order from Honda they have a colour System for the parts and have no way of telling what what. Or does anyone know any good suppliers for parts
Hello there! I was rebuilding my carbs while looking at the Honda fiches, and saw that a gasket on my carb is positioned differently. On the fiches, the order is: 28-1-15, so the metal collar (15) sits on the carb, the gasket (1) sits on the metal collar, and the plastic plate (28) sits on the...
Later in the year I will be rebuilding my front forks with progressive springs, in respect of the seals do I need to order one of these kits:
2 Oil Seals
2 Dust Seals
2 Retaining Clips
2 Inner Bushes
2 Outer Bushes
Or can I just order the seals?
Also what fork oil...
I am using this site to try and order some bolts that I require to put the original backend on the bike
question I have is this, to order the bolts for the carrier(I have the collars) it shows bolt number 27 for the middle...
Hi, I've just joined and am finding my way around . Looked far and wide for a long time to get a 70's XL but luckily I managed to buy my 1980 XL500s from someone a few streets away. Only issue I have that's recently arisen is an electrical one and have a new battery on order.
Sent from my...
Come with 1 Year Warranty 100% Guaranteed Lowest Price
Free shipping worldwide via FedEx. 110% Guaranteed Money back in 5 days
We ship same day, As soon as we received the payment
Pickup is 100% Permitted
Email: inquiries (at) BizFests . com
Website www . BizFests . com
I need to remove the two freeze plugs on the crankshaft to clean the oil pipes between the main journals and the crankpins journals.
Diameter of these plug is 11,5mm and height about 5 mm.
Does anyone know where I can order this king of plug ? In France, it's by now impossible ...
HELP needed... my speedo has stopped working... local garage has advise i order full replacement of the speedo drive not just the cog etc...
Anyone recommend where i could find one not at stupid money??