How the heck do I open it? The entire bike is dead and I suspect (aka I hope) a blown main fuse but I can't get into the box and whilst I could force...I don't really want it.
There's what appears to be a tab on the "front" (that's the say the side of the box closest to the rear of the bike). Is...
The swingingarm on Dommies always got a bad press. Has anyone done a mod on a swingingarm?
What other s/arms could I slot in? have you done it ? if so some pix would be nice.
Are there any threads or posts I can look at / tvm
Since getting my RD07 a few weeks back, I have not been able to successfully put the bike in the centre stand once!
It looks to me like the 'lever' part that you press down on is missing, so you have nothing to put your foot onto!
I've had plenty of heavier bikes before and never...
I am replacing my clutch soon and considering replacing the clutch bearing at the same time. I don't have the service manual at hand, and I am wondering if the clutch bearing can be easily replaced without special tools or if it has to be pressed onto the shaft and/or into the basket?
Dead Dommie, no lights nothing. Batt 12.8 volts disconnected. 2 volts connected with ignition on. Drops to 1 volt if i press horn etc. is the battery duff or could something else be causing this. Cheers.
I am having trouble dipping the mainbeam. The switch only works if I press and hold the button very hard for a couple of seconds, sometimes repeatedly. And by the then need is usually passed anyway! It works spot on going back to mainbeam. I'm not very confident on LX. Any advice on dismantling...
I've got a -00 RD07 (50000km) which I am quite happy with. Recently however I've painfully noticed that sometimes when I shift down to a lower gear on high speed I loose the gear. Usually I just press the clutch and clonk the shifter and all is fine again.
Do I have to start...
hello there im new to this forum and i am having some trouble with my new bearing kit, not to mention the chew i had getting the swingarm bolt out:angry4:. I bought a new swingarm bearing kit for the bike and when i removed the old ones i noticed there are no stoppers for the bearings to sit up...
I've just bought a new laptop and am having a problem writing messages on the forum. When I press enter to start a new paragraph, nothing happens. The cursor doesn't move down so I can start a new paragraph. This doesn't happen in Hotmail, so can anyone tell me whats wrong and how I can fix it...
If you need to launch a new model or get good press for an exhisting model there's no better way than to get James bond to test ride it for you.
Honda is proud to join the elite Bond vehicles with the CRF250R | eNews | News | Honda (UK)
Is the choke nipple bit supposed to slide into the hole, or does it just press against it. Maybe a dumb question, but when i srew my choke cable in on the carbs I am unable to pull the lever.
I have taken pictures but I don't know how to insert them.
Hi, Hope some one can shed some light on a problem I am having on my comuter bike :(
The bike is a 2008 Honda CG125 ES with 21,000 miles,
The problem I have got is that it will not start when I press the starter, all that happens is the neutral light dims, if I put the bike in gear and rock...