Hello, Balam from Mexico here.
I have undertaken the task of calibrating my valves. All went well with rear cylinder, but my front cylinder has a problem. Intakes valves are good. Exhaust valve is waaaaay too tight. I can get no feeler gauge in!
What's going on? Is my timing chain off? Is the...
Been sat in the garage about two years and used once
Not been ran for about 8 months
Should all work ok
Givi wing rack
Not going to clean it or bother trying to start
Located in Sheffield
Delivery available at a price and not to far away
V5 present and correct
for sale is an Ignitech CDI .. bought for my RD07a but never needed it.. as the fault I thought was in the CDi was found elsewhere. But I ran this in the bike and it worked perfect.
comes with optional extra of the connector adapter.
SPARKER TCIP4 - IgniTech P?elou?
€100 + postage and packaging
can anyone tell me the correct way up for the forked arm on the rear suspension of a 650 tranny.
mine is fitted with the lower shock absorber mounting lug being lower than the pivot point but this photograph shows it the other way up ie with the shock mounting above the pivot
Hi folks any recommendations on a bike jack ?
I have an aba stand that I can fiddle to fit the dareo and the tranny but would like something that I can use on a whim
Seen a few on amazon but some look like mechano
Sent from my SM-T580 using Tapatalk
Bike 650 trannie.Headlight bulb replaced,now HISS light stays on all the time with ignition on.Flicking the kill switch on off makes no difference.Will crank over till doomsday with no results.Fiddled around with wireing under the clocks but no luck,What have i displaced.Any suggestions...
Just a question on the starter button..just put my tank bag on..and started the bike..when moving the bike outside the garage i touched the starter button with tank bag , starter motor ran..is this right..or is there a switch faulty...
Bloody only gone and crashed the tranny ( 650 ) in a local ford got covered head to toe in mud but was only shaken thank the lord , Fortunatly the tranny seems ok apart from a bent set of bars .
anyone replaced there bars , if so whats the best no / little fuss option ?
I have no handbook for my Transalp, can anyone just run me through the fuel gauge, I know the bars drop off as you use fuel, I have been down to one bar remaining, what happens next?
Or do I just splutter to a halt...:lol:
Also if anyone has an owners manual they don't want, I'm after...
Transalp right hand under seat panel in red
Does anyone have a spare right hand under seat fairing panel in red to fit a 2001 Xl650 Tranny?
Mine got atomised following a reasonably innocuous fall :(
I have a Xr 250 with the following FMF q4 end can with standard header, standard air box k&n air filter
But seems very flat at the bottom end. I tried to remove the air box snorkal but the engine ran fought and bogged from take off. I am trying to find out what jetting I need to sort it.
I developed a back fire on my tranny. have balanced that carbs and it still does it. the only thing I can find wrong is the PAIR valve seems to be open all the time will this do it. if so can I cut it out?.