roller

Has anybody found an aftermarket supplier for the needle roller bearings on the 650 shock link, I only want the two where the long link attaches to the swing arm but at Honda prices just over £30 each they are a bit dear! Iv'e found the same size bearing at bearing shops BUT they are the caged...

I'm trying to find a replacement set of steering head bearings for my 700 Transalp. Preferably looking to replace the stock bearings with roller bearings. Don't suppose anyone knows where I should be looking? I've had a go at googling it but I can't find the specs for the standard bearings to...

Hi , just had my varadero over a week , spotted that it says grip heater on each grip but they don't get hot and there's no switch or controller for them .... Am I missing something or are they just not working ? They look like genuine Honda grips . Chris

Hi, Does anyone have the sizes for tapered roller bearings if I want to upgrade mine from the ball bearings?

Hi , I've just fitted an ignitech controller to my fmx 650 and was wondering if any body has any good advance settings for these units thanks Neil

Wanted: All four indicators for an RD07A Africa twin, also the chain roller guard think thats what its called, the white plastic piece that guides the chain.

Hi, i am converting an xl500 to disc by putting a B reg xr250 front end on...can anyone tell me the outer diameter of the xr250 shells that drop into the headstock for the needle roller bearings ?

Don't know if anyone has any 00 track for sale, September i'm going to board my mothers loft out and run 4 trainsets interlinked which will be roughly 12ft square so i need as much track as i can get, long straights are a must but anything considered if anybody has any for sale. May also...

Just bought fog lights and controller for my 08 XL700. Has anyone fitted these themselves? Is it a complicated job best left to a professional, or should I have a go at it?

I've got to replace the steering head bearings on my 650 TA. I believe the std ones are caged balls. I've seen taper rollers on Wemoto - anyone any experience of these? Or indeed any advice? Thanks FO

Hi Guys Just finished doing my steering head brgs today on My 99 xl600vx. The old standard ball races were so shot it would only go in a straight line! Got a set of taper rollers complete with seals from Wemoto and set about the job.. Stripped off the front fairing uppers, wheel out and bars...

:o Following the thread of that french roller skate man (who was very cool) Check this s--t out : http://www.youtube.com/watch?v=O4uSJWp3gVQ