Cdi unit Tested on my 600. (carry a spare on your bike) £20.
voltage rectifier Tested £15
speedo drive with cable £15
rear foot peg brackets with foot pegs £10 each.
Belly pan £10.
LH Radiator. No leaks. £15.
Cooling fan. working. £15
Fork bottom legs From a 1989 model £15 each.
rear rack. £15...
Anyone taken the oil strainer out of the bottom of their frame?
Tried removing it yesterday, so i could check it, and get frame ready for powder coat, but could not get it to undo.
Tried interlocking two spanners to get a higher torque, but still no joy.
Any tips on removal???
i have this and it seems a shame to bin it
genuine 600 exhaust muffler/silencer
the 'bottom' end is is perfect nick, but there is rust and a 8mm hole on the rear - easy fix for someone who can weld or rivet a plate on top?
collect north London or £10 postage (uk)
Has anyone had any experience with pod filters such as those that can be used on the Honda Hawk
My airbox has seen better days I think the snokel pipes have shrunk / degraded...
Hello co-africans i have a problem. When mybike is on neutral and only on neutral and only when its cold and I pull the throttle I hear a clicking noise coming from the bottom right of the engine
It stops after 10 minutes when the bike is better warmed. Should i worry cause i am frightened as a...
I'm trying to restore my bike and the existing headlamp cowling was repaired and resprayed using rattle cans by the previous owner.
Does anyone have one still in original red colour and with the right Honda sticker, that they are planning to sell at some point? If so, please message me...
Hi all, i have been looking at getting some crash bars fitted to my XL650 v Transalp but was hoping for some advice as to what make or type to get.
I have managed to find the following two makes which seem to offer good protection to the upper parts of the bike ( the expensive bits )
I have a bottom end for a XL600R, it the red magnesium casing complete with crank and con-rod. Also have two pairs of cylinders and a complete set of dellorto carbs (two together) and wish to sell them off. WOuld rather offer them to the community instead of eBay.
Will accept a reasonable offer...
Does any one have one of these for an RDO4 please ? the one i fitted for an RD07 is causing me a few problems.
it fits on the bottom of the rear shock
Also im after one of those stickers below for the front or know where i can get one please.
Just bought a 2001 Varadero 1000 which is an import from Europe, so my question is that I need a UK spec headlight and speedo, did Honda use a headlight from another bike on the Vardero or am I stuck with shelling big bucks out for a new one. If anyone can point me in the direction of...
i'm having trouble splitting the bottom engine case on my 82 Xl500r,
i have to replace the kick start return spring, i have the engine upside down on the head & I've removed all the exterior screws, are there any internal screws i have to remove & what is the best way to separate them...
Getting Stoned in Gloucestershire- A selection of historic locations to visit in Gloucestershire including boundary & standing stones,& ancient crosses. You visit them in your own time between 1st May and 30th September. At each location you will need to answer a clue/question about the stone...
Wondering around Tesco like a zombie as usual, I stumbled on this - Garmin Drive 50 LMT Travel Edition with Worldwide maps at £85. I know it wont be water proof and fiddly to use perhaps, but at £85 its a shed load cheaper than a bike Nav?:thumbright:
Anyone tried this out? Perhaps in...
I have damaged the left hand fork slider (bottom at the thread where the spindle screws in). I can get second hand ones from ebay but they are from the single
disk model. Now, the single disk model has the disk on the l/h/s, good, I obviously need the mounts for the calliper, but are they the...